SuperCrop Row-Crop Header - Bish Enterprises

• Hydraulic Row-Unit Angle (First-of-its-Kind!) – Adjust snoot pitch from the cab in seconds to match crop height or flatten for lodged sorghum — keeps ground speed up and virtually eliminates field loss.
• Rear-mounted sickle knife – Cutting behind the gathering chains virtually ends head-shatter in sorghum & sunflowers and guarantees a 14+ inch stubble that boosts moisture capture and winter forage.
• Full-finger, large-diameter auger – Aggressive fingers span the entire auger to grab both dry leaves and green stems—feeds evenly, prevents slugs, and protects combine concaves.
• Low-friction poly dividers & snoots – Smooth, replaceable poly glides under tangled sorghum or hemp and shields leaves so less trash hits the feeder chain—better threshing, cleaner grain.
• No overhead reel (hemp) – Eliminates the wrap point in hemp grain harvest, dropping fiber downtime to near-zero and keeping fragile seed heads intact.
• Hydraulic chain-speed option (millet) – Dial chains down to a crawl in light millet heads—reduces non-seed material entering the rotor and keeps test weight up.
• Adjustable deck plates & 15-min knife swaps (popcorn / low-yield corn) – Adjustable deck plates capture narrow stalks with no stalk roller to cause butt shelling; quick-change knife sections swap with three bolts so operators can move from soft-stem crops to tough corn in minutes.
• Ultra-low maintenance – No spinning discs, no reel bearings, and fewer gearboxes than draper or kit conversions—daily grease takes < 5 minutes.
• Operating-cost champion – 30 % less load on the combine rotor saves 25-35 % fuel and tests show up to 50 % lower wear-part spend versus draper/platform headers over a three-season span.

For more information, please visit our website.

Setting up your row crop cultivator correctly is critical for success with hoeing, and therefore with your harvest. Allow yourself enough time to set up your hoeing technology correctly and professionally. If you put in an adequate amount of time and exercise patience, you will be rewarded for it later on.

Xinwanda are exported all over the world and different industries with quality first. Our belief is to provide our customers with more and better high value-added products. Let's create a better future together.

As a general rule based on the above: There is no one setting to match all conditions and crops. A row crop cultivator must be adapted to the crop (including its size) as well as the soil and weather conditions. Hoeing only becomes easier and more precise with experience. Calmness and patience are required, because using a row crop cultivator correctly contributes significantly to the success of the harvest.

The above-mentioned points are based on practical experience and depend on conditions and the results can vary. Einböck does not bear any responsibility on correctness and cannot bear any liability for damage on crop / machines!

The company is the world’s best row crop header supplier. We are your one-stop shop for all needs. Our staff are highly-specialized and will help you find the product you need.